Aircon Not Turning On? 8 Causes and Quick Fixes

Eight reasons an aircon will not turn on, from quick owner checks like batteries and the isolator to faults that need a technician.
Aircon Not Turning On? 8 Causes and Quick Fixes | Wei Wei Aircon
11.17.2026

If your aircon is not turning on, start with the simple checks: remote batteries, the isolator switch, the timer settings and the circuit breaker. If all of those are fine and the unit still shows no response, the cause is usually inside the unit, such as a blown fuse on the circuit board, a faulty capacitor, a triggered float switch or loose wiring, and that needs a technician.

Few things are more frustrating on a hot Singapore night than pressing the remote and getting nothing back. The good news is that a fair number of “dead aircon” calls turn out to be something you can fix in five minutes. This guide walks through eight causes in order, from the quick owner checks to the faults that need a professional.

First, Is It Really Not Turning On?

Before going through the list, be clear about what you are seeing, because different symptoms point to different problems.

  • Completely dead. No beep, no light, louvre does not open. This points to power, the remote or the control board.
  • Beeps and lights up, but no air. The unit is receiving the signal but something stops the fan from running.
  • Fan blows, but air is not cold. The unit is on, so this is a cooling problem rather than a power problem. Our post on why an aircon is not cold covers that.
  • Turns on, then a blinking light. The unit has detected a fault and stopped itself. Note the blink pattern or error code for the technician.

Also remember that many units deliberately wait a few minutes before restarting the compressor after being switched off. That delay is normal protection, explained in our post on the 3-minute rule for aircon, and it is not the same as the unit refusing to turn on.

Quick Aircon Fix Checks You Can Do Yourself

The first four causes are owner checks. None of them need tools or opening the unit.

1. Flat or faulty remote batteries

This is the most common cause by far. If the remote screen is faint, blank or flickering, replace both batteries with fresh ones of the same type. If the screen looks fine but the unit still ignores it, point the remote at your phone camera and press a button. On many phones you will see the infrared light flash on screen. No flash usually means the remote itself is faulty.

Also check that nothing is blocking the receiver window on the indoor unit, and that the remote is set to the right mode. Some remotes accidentally get switched to a different setting or child lock.

2. Isolator switch turned off

Most split aircons in Singapore homes have an isolator switch near the indoor unit or at the outdoor unit. It is easy for a helper, contractor or family member to switch it off and forget. Check that it is in the on position, then wait a minute and try the remote again.

3. Timer or schedule settings

An off timer, sleep timer or a schedule set on a smart controller can stop the unit at a set time and stop it from responding the way you expect. Cancel all timers on the remote, and if you use an app or smart controller, check the schedule there too.

4. Tripped circuit breaker

Open your distribution board and look for a breaker in the down or off position. If the aircon breaker has tripped, you can switch it back on once. If it trips again, leave it off and call for help, because repeated tripping usually means an electrical fault. Breaker tripping has its own causes and dangers, so do not keep resetting it.

Technician-Level Causes of an Aircon Not Turning On

If the four checks above are fine, the problem is almost always inside the unit. These are the causes our technicians find most often.

5. Blown fuse on the circuit board

The indoor unit’s printed circuit board (PCB) usually has a small fuse to protect it. A power surge, lightning or a short elsewhere can blow it, leaving the unit completely dead. Replacing the fuse is simple, but a good technician will also check why it blew, because a new fuse on a shorted board will just blow again.

6. Faulty capacitor

Many aircon fan motors and compressors use a capacitor to help them start. When a capacitor weakens, the motor hums or fails to start at all. It is a common wear part in our hot, humid climate, and a technician can test it with a meter and replace it if it is out of spec.

7. Float switch or drain safety triggered

Ceiling cassette and ducted units, and some others, have a float switch in the drain pan. If water builds up because the drain is choked or the drain pump has failed, the float rises and cuts the unit off to prevent an overflow onto your ceiling. Clearing the drain and checking the pump usually brings it back. This is one of the faults that regular aircon servicing helps prevent, since flushing the drain line is part of a proper service.

8. Loose wiring, faulty transformer or PCB failure

Vibration, heat and moisture can loosen terminals over the years, and pests sometimes chew wiring near the outdoor unit. On some units, a failed transformer on the board means the control circuit never powers up. In other cases, the PCB itself has failed, often after a power surge or long exposure to moisture. These need proper testing to confirm before any part is replaced.

Symptom Table: What Your Aircon Is Telling You

What you see Likely cause What to do
Remote screen blank or faint Flat batteries Replace batteries
Remote screen fine, no beep from unit Faulty remote, blocked receiver, isolator off Test remote with phone camera, check isolator
Unit stops at the same time daily Timer or schedule Cancel all timers
Breaker is down Electrical overload or fault Reset once, call if it trips again
Completely dead after a storm or power cut Blown PCB fuse or damaged board Call a technician
Beeps, then hums but fan does not spin Weak capacitor or fan motor problem Call a technician
Cassette or ducted unit stops, water in drain pan Float switch, choked drain, failed drain pump Call a technician
Unit works on and off for no clear reason Loose wiring or failing board Call a technician

What Not to Do When Your Aircon Will Not Start

  • Do not keep flipping the breaker. If it trips twice, there is a reason. Forcing it can damage the unit or wiring.
  • Do not open the casing. The PCB and capacitors can hold a charge and there is mains voltage inside.
  • Do not spray water or cleaner into the indoor unit to “wake it up”. Water near the board can turn a small fault into a board replacement.
  • Do not rewire anything yourself. Electrical work on your home installation, such as new circuits or wiring, should be done by an EMA licensed electrical worker. You can check one on EMA’s guide to verifying a licensed electrical worker.

When to Book Aircon Repair

Book aircon repair if the unit is still dead after the four owner checks, if the breaker trips more than once, if you smell burning, or if the problem started right after a thunderstorm or power outage. Also book a check if only one indoor unit on a multi-split system is dead while the others work, since that narrows the fault to that unit’s board, wiring or sensors.

Repair costs depend mainly on which part has failed. A fuse or capacitor is at the cheaper end, while a PCB or fan motor costs more. Our post on aircon repair cost in Singapore breaks down the main factors so you know what to expect before the technician arrives.

If your aircon is turning on but showing other odd behaviour, like leaking, noise or weak airflow, our aircon troubleshooting guide is a good next stop.

How to Reduce the Chance of It Happening Again

  • Keep the drain clear. Regular servicing flushes the drain line, which matters most for cassette and ducted units with float switches.
  • Protect against surges. If your unit died after a storm before, ask an electrician whether surge protection suits your home installation.
  • Keep the outdoor area clean. Clutter on the ledge can hide pest nests, and pests are a common cause of chewed wiring.
  • Act on early warnings. Clicking without starting, intermittent shutdowns and burning smells usually come before a total failure.

How Wei Wei Aircon Handles a Unit That Will Not Turn On

We have been repairing aircon in Singapore for over three decades, across all major brands and unit types. When you call, we will first walk you through the quick checks over the phone. If the batteries, isolator, timer and breaker are fine, we arrange a visit.

On site, we test the power supply to the unit, check the fuse, capacitor, float switch and wiring, and confirm the fault before replacing anything. You get a clear quote before the repair goes ahead, and we explain what failed and why, so you know whether it is a one-off or a sign of something larger.

Frequently Asked Questions

Why is my aircon not turning on with the remote?

The most common reasons are flat remote batteries, a faulty remote, or the isolator switch being off. Replace the batteries and test the remote with your phone camera. If the remote works but the unit does not respond, the problem is likely inside the unit.

Why is my aircon not turning on after a power outage?

A power outage or surge can trip the breaker or blow the fuse on the circuit board. Check the breaker first and reset it once. If the unit is still dead, a technician needs to check the fuse and board.

How do I reset my aircon if it won’t turn on?

Switch off the isolator switch, wait a few minutes, then switch it back on and try the remote. If the breaker has tripped, you can switch it back on once. If neither brings the unit back, call for repair.

Why does my aircon beep but not turn on?

A beep means the indoor unit is receiving the remote signal and has power. If nothing else happens, the cause is often a faulty fan motor, a weak capacitor, a triggered float switch or a board fault. These need a technician to diagnose.

Can a dirty aircon stop it from turning on?

Dirt alone rarely stops a unit from powering up, but it can lead to a choked drain that triggers the float switch on cassette and ducted units. Dust and moisture build-up can also contribute to board and motor faults over time.

Is it safe to keep resetting the circuit breaker for my aircon?

No. You can reset it once, but if it trips again there is an electrical fault that needs checking. Repeated resets can damage the unit and the wiring.

Book Your Aircon Servicing Today

Enjoy guaranteed workmanship, clear quotes, and expert care from Wei Wei Aircon.

  • Phone: +65 6567 7698
  • Location: 451 Jurong West Street 42, #01-180, Singapore 640451
  • Operating Hours: Mon-Sat: 9:00 AM – 6:00 PM

Send Us a Message

You can schedule an appointment or send us your enquiry by filling up the form, or simply give us a call. 

6567 7698

Related Posts

Call Now Button